Wall-mounted door stop, dual installation, knurled design, 198

Textured door stop with unique diamond knurled design. Offers 2 installation options: by adhesive or by screw (includes expansion plug and screw).

Designed and manufactured by Herrajes EVI with solid bars, obtaining a robust and high quality doorstop. To protect doors and prevent damage to walls, radiators or any other element of the room.

This is a very original and modern stopper with a differentiating style thanks to its texture with cross pattern. The measurements of the adhesive stopper are as follows: 28 millimeters in diameter and 28 millimeters high.

Available in the following finishes:

• Matt stainless steel and silicone rubber in white.
• Matt stainless steel and silicone rubber in black colour.
• White lacquered stainless steel and white silicone rubber.
• Black lacquered stainless steel and silicone rubber in black colour.
• Matt satin brass and rubber in white.
• Matt satin brass and rubber in black colour.
• Brass with antique leather finish and black rubber.
• Brass rustic finish and black rubber.

In addition, we recommend visiting our textured bumpers with linear pattern: Adhesive Door Stop, Linear Knurling, 198.

Install your doorstop with adhesive:

1. Choose the installation site.
2. Clean the surface with a damp cloth, making sure there is no residue. Then dry thoroughly.
3. We recommend heating the adhesive pad slightly with a hair dryer, without removing the protective film of the adhesive, to enhance its adhesion capacity.
4. Remove the protective film. Do not touch the adhesive with your hands, as it could lose its adhesion properties.
5. Install the doorstop in the desired location and press firmly for 1 minute.
6. After installation, wait 24 hours for the adhesive to set so that it can perform its function as a stopper correctly.

*We do not recommend the installation of adhesive door stoppers on rough surfaces, in that case we recommend the stoppers with screw fixation.

**We recommend not to move the stopper once installed. The adhesive may lose adhesion if the stop is handled once installed.

Install your screw-on stop:

1. Choose the installation site and mark the location to drill the hole.
2. Drill the hole with the appropriate tool.
3. Clean the remains of the material with a damp cloth.
4. Remove the rubber from the body, place the dowel and screw the body of the stop to the surface.
5. Place the rubber on the body again.

➜ Discover our replacement rubber packs for this model here.